Factory Operation Safety Maintenance And Service Manual For JLG Boom Lift. Manual For Owners And Operators. It Contains Important Information And Instructions For Maintenance Description Of The Functions And Capabilities Of The System. Description Of Possible Faults / Problems And Their Solution.

Format: PDF (ZIP File)
Language: ITA; FRA; ESP; SWE; DEN; ENG; GER; RUS
Quantity of Manuals: 8
Pages: 135; 135; 135; 135; 171; 172; 173; 172
Number: X17JR021 (march 2011); X17JR023 (march 2011); X17JR025 (march 2011); X17JR027 (march 2011); X17JR039 (may 2012); X17JR042 (january 2013); X17JR044 (january 2013); X17JR0411 (january 2013)
Searchable: Yes
Wiring Diagrams: Yes
Hydraulic Diagrams: Yes

Model

JLG Boom Lift
X17J

Contents

PRESENTATION
-TECHNICAL INFORMATION
Description Of The Machine
General Safety Standards
Safety Warnings
-SAFETY DEVICES
Battery Cutout Switch
Distributor Pressure Relief Valves
Cylinder Stop Valves
Alignment Photocell On The Aerial Part Of The Structure And The Base Of The Machine
Stabilizer Position Microswitches
Jib Position Microswitch
Basket Load Sensor
Control Protection
Spirit Level
Pin Locking Bolts And Nuts
Safety Device Electronic Control Board
-INSTRUMENTS AND CONTROLS
Radio Control
Footswitch
Control Positions
-EMERGENCY DEVICES
Emergency Stop Button
Hand Pump
Solenoid Valves For Emergency’ Descent
Safety Device Bypass Key
Emergency Position Controls
Switch To Enable Emergency’ Controls
-USING THE MACHINE
Safety Standards To Adopt Before Using The Platform
Procedures For Correct Use
Working Area
Using The Elevating Work Platform
Emergency Manoeuvres
Recharging The Radio Control And Making An Emergency Electrical Connection
Recharging The Battery
Main Intended Uses Of The Platform
-MAINTENANCE
Safety Instructions For Greasing And Lubrication
Table Of Recommended Lubricants
Greasing Points
Greasing The Telescopic Arm
Safety Instructions For Maintenance Operations
Periodic Maintenance Intervals
Electric Motor
Inspection And Maintenance
General Periodic Checks
Maintenance On The Rubber Tracks
Checking Tightness Of Nuts And Bolts
Checking The Hydraulic Oil Level
Checking For Leaks In The Hydraulic System
Checking The Condition Of The Filter Cartridge
Checking That All The Plates Are Present On The Machine And Intact
Checking The Operating Pressure Of The Hydraulic System
Checking Tightness Of The Fastening Screws On The Pin Retainers And The Locknuts
Checking Wear On The Extension Arm Internal Sliding Ring
Checking Wear On The Telescopic Arm Slides
Checking Tightness Of The Turntable Bolts
Battery: Checks And Maintenance
Battery Pack Operating Specifications
Servicing The Engine Thermic Version
-SAFETY STANDARDS FOR TRANSPORT
Removing Die Basket
Loading And Unloading The Machine On Transport Vehicles Using Ramps
Lifting The Machine
Transporting The Machine
-SERVICE MENU ON THE RADIO CONTROL
Input Menu
Error Menu
Operating Hours Menu
Settings Menu
Joystick Menu
TROUBLESHOOTING
-CHECKS TO BE COMTLETED ON THE MACHINE FOLLOWING REPAIRS
Checking Correct Operation Of The Controls
Checking Operation Of The Safety Devices
-HYDRAULIC SYSTEM
Hydraulic System Diagram Thermic Version
Hydraulic System Diagram Lithium Version
WIRING DIAGRAM