Factory Technical Manual Manual For Yanmar Diesel Tractor. Manual Contains Illustrations, Instructions, Diagrams For Step By Step Remove And Install, Assembly And Disassembly, Service, Inspection, Repair, Troubleshooting, Tune-Ups.

Format: PDF
Language: English
Pages: 1001
Issued: july 2009
Bookmarks: Yes
Wiring Diagrams: Yes
Hydraulic Diagrams: Yes

Model

Yanmar Diesel Tractor
EA2400

Contents

-SAFETY
Safety Practices
Signal Words
Before Working on Equipment
Tire Safety
Batteries and Battery Acid
Exercise Care Around High Pressure Fluid Lines
Servicing the Cooling System Safely
Avoid Contact with Rotating Blades, Augers, and PTO Shafts
Environment and Ecology
Chemical Products Safety Information
Before Returning Equipment to Service
Important Federal Laws and Regulations Concerning Employers, Employees, and Operations
Employee Tractor Operating Instructions
Child Labor Under 16 Years Old
-INTRODUCTION
Shop Handbook Intent and Use
Engine
Hydro-Static Transmission
Fasteners
Assembly Procedures
The Tractor
Special Tools
Fluids and Lubricants
Torque Tables
Identyfying Hardware
Hydraulic Fittings
Torque Specifications
-ENGINE
Introduction
Yanmar Warranties
Safety
General Service Information
Periodic Maintenance
Engine
Fuel System
Cooling System
Lubrication System
Starter Motor
Alternator
Electric Wiring
Troubleshooting
-ELECTRICAL
General Information
Electrical System Specifications
Component Location
System Component
Circuit Diagnosis
Diagnosis and Replacement Work for Electrical Components
-POWER TRAIN – HYDROSTATIC
Component Location
Theory of Operation
Diagnostics
Test and Adjustment
Repair
-HYDRAULICS
Schematics
Component Location
Theory of Operation
Diagnostics
Tests and Adjustments
Annex
-STEERING
Component Location
Theory of Operation
Diagnostics
Tests and Adjustments
-BRAKES
Component Location
Theory of Operation
Diagnostics
Tests and Adjustments
-MISCELLANEOUS
Component Location
Tests and Adjustments
Accelerator / Throttle Adjustment
-REPAIR
Preparation
3-Point Hitch Separation
Hood
Turn Signal / Hazard Light Removal
Roll-Over Protective Structure (ROPS) Upper
Safety belt / Seat
Seat Stay
Hydro Static Transmission (HST) Pedal
Footrest
Fender Disassembly
Front Tire
Rear Tire
Power Steering (PST) Cylinder
Front Drive Shaft
Front Axle
Steering Wheel
Battery
Hour Meter Cable
Front Grip
Dashboard Upper
Dashboard Upper Switch
Instrument Panel
Dashboard Bottom Cover
Air Cleaner
Exhaust Pipe & Muffler
Engine Control Cable
Engine Control Lever
Engine
Engine Mount
Coolant Tank
Fuel Filter and Fuel Feed Pump
Radiator
Power Steering Valve
Steering Bracket
Oil Cooler
Hydraulic Pipes
Main Drive Shaft
Column Bracket
Fuel Tank
Fuel Sensor
Power Take Off (PTO) Safety Cover
Removing the Lift Cylinder
Disassembling the Lift Cylinder
Removing the Implement Control Valve Quick Coupler
Removing the Implement Control Valve Assembly
Disassembling the Implement Control Valve Assembly
Removing the Control Valve
Disassembling the Control Valve
Removing the Rear Frame
Foot Brake Pedal Disassembly
Tips: Reassembly Procedure
-REPLACEMENT
Replacement of Broken Power Take Off (PTO) Bearing or Gear
Replacement of Hood And Headlight
Replacement of Radiator
Replacement of Rear Axle Oil Seal and Rear Axle Case
Replacement of Front Axle Oil Seal
Replacement of Power Take Off (PTO) Shaft Oil Seal
Replacement of Implement Control Valve
Replacement of Power Steering Valve and Hose
Replacement of Power Steering (PST) Cylinder
Replacement of Instrument Panel / Panel Illumination Light
Replacement of Lift Cylinder
Replacement of Front Center Pin (Including Bushing and Seal)
Replacement of Thermostat
Replacement of Fuel Shutoff Solenoid Valve
Replacement of Fuel Filter and Fuel Feed Pump
Replacement of 3-Point Hitch
Replacement of Fuel Tank
Replacement of RPM Meter Cable
Replacement of Engine Mount
Replacement of Fuel Sensor
Replacement of Dashboard Upper Switch
Replacement of Flasher Unit
Replacement of Accelerator / Throttle
Replacement of Oil Cooler
Replacement of Main Drive Shaft
Replacement of Various Lamp Bulbs